Linear Gate Not Responding? We'll Diagnose It Today

Call Now — 1-800-770-9642 Request Service

Why We're Linear Gate Specialists

Linear has been supplying gate operators to the residential and light-commercial market for decades, and their products are found in everything from tract-home HOA communities to rural ranch entrances. Linear's main service challenge is PCB corrosion — their control boards use an open-architecture design that's more susceptible to moisture and insect ingress than enclosure-sealed competitors. We've also seen consistent loop detector module failures on Linear systems installed on busy driveways, where vehicle EMF interference degrades the detector frequency over time. Our stock of Linear replacement boards and loop detector modules means most Linear calls are fixed same-day.

Common Linear Models We Service

LDCG

LDCO

LCO100

LCO200

LSO

LSW

LS050

LS100

LS200

AE100

Common Linear Problems We Fix

Control board corrosion from moisture and insect damage

Loop detector frequency drift from vehicle EMF interference

Motor capacitor failure on AC motor models

Limit switch potentiometer failure

RF receiver sensitivity loss (remote range drops off)

Clutch slippage on slide gate models

Our Work

Linear Repairs — Real Jobs, Real Results

Request Service

Need Linear Gate Repair?

A Linear specialist will call you within 30–60 minutes. Upfront pricing, no obligation.

FAQ

Straight Answers to Real Gate Problems

My Linear gate stopped responding to remotes — the LED doesn't even blink. Is the board dead?

Not necessarily. First check the board power — a blown fuse on the AC input is common after a power surge. If power is present and the board is still unresponsive, the main processor IC or the RF receiver module may have failed.

My Linear gate opens but takes 45 seconds to close fully — is that a setting?

Close delay is configurable on most Linear models. But if it was previously faster, the issue may be a partially seized drive chain, a dragging gate leaf on the track, or a weak capacitor.

Can you add a wireless keypad to my existing Linear system?

Yes. Linear's MDC-2 and similar wireless accessories pair to the existing receiver. We supply, program, and test during the service call.

My Linear gate operator makes a clicking noise when it moves — what causes that?

Clicking during movement usually indicates chain or drive belt wear, a loose drive sprocket, or a worn idler. We inspect the drive system and replace worn components.

Expert Linear Service — Call Today

Available 24/7 for emergencies. Most repairs completed same day.